KEEL-01 / OPTION 3 END PORTALS 27 SEP 2026
Flat floor.
Two end portals.
A new four-part study removes the two lengthwise bottom rails. Short-end frames bear a continuous basket floor; screws enter from outside the towers and meet nuts inside the end walls. Orbit the actual source geometry below.
01 / EXPLORE
The Option 3 assembly
Drag to orbit, scroll or pinch to zoom. Explode lifts the basket and top while moving each end portal outward. Ghost reveals the floor shelves and screw locations.
Actual Option 3 meshes · geometry study only
Keyboard: focus the 3D view, use arrow keys to pan, Shift + arrows to orbit, + or − to zoom, and 0 to reset. The buttons above work by keyboard too.
02 / LOAD PATH
Short sills stay.
Each end portal joins two towers with a low transverse sill. A shelf on that sill reaches under the basket end, so the screws are intended to clamp and retain the basket while the shelves bear downward load. The long floor slots, rails and elastic eyelets are absent. The integrated top is the same mesh as V4.

03 / INSPECT
What changes at the floor.
The sheet shows assembled, separated and drop positions. The cutaway shows one outside-driven screw path through the tower, the end-wall pad and its top-open nut pocket. Hardware volumes are generic proxies.
04 / EVIDENCE & FILES
A first article in progress.
The 39 passing modeled checks cover connected bodies, nominal collision and insertion samples, floor continuity, screw passages, shelf bearing and print-pose bounding boxes. The 461 g figure is solid-volume arithmetic at assumed density, not slicer consumption.
- Form
- Daniel authorized this geometry for a first-article print; final form acceptance is open.
- The H2C reported FINISH and the A1 mini basket was still running at the 27 September evening monitor snapshot. Cooled-part condition is unverified.
- Open
- Floor flex, end-wall peel, shelf bending, fastener fit and asymmetric carry.
Source-derived geometry
Basket STL ↓Left end portal STL ↓Right end portal STL ↓Integrated top STL ↓Geometry identity JSON ↗These are geometry exports for inspection. The final native sliced packages were not retained; effective print settings and physical quality remain unverified.

